Mode Operation; Battery Recharge; Operating Power - ADJ PINPOINT GO TW User Instructions

PinPoint GO TW
Energy Saving Mode:
There are 2 ways you can set the PinPoint GO TW into energy sav-
ing mode. When the PinPoint GO TW is set into energy saving mode,
it will decrease the LED brightness gradually when the battery life is
less than 80% to extend the battery life.
NOTE:When the unit is using DC power, the energy saving mode
cannot be used.
1. Press the MODE button for 5 seconds to switch between normal
mode and energy saving mode. When all the LED's flash 2 times, the
PinPoint GO TW is in normal mode. When the Amber LED flashes for
5 seconds the PinPoint GO TW is in energy saving mode.
2. Using the ADJ LED RC3, press the BLACKOUT button for 5 sec-
onds to switch between normal mode and energy saving mode. When
all the LED's flash 2 times, the PinPoint GO TW is in normal mode.
When the Amber LED flashes for 5 seconds the PinPoint GO TW is in
energy saving mode.
Low Battery Warning:
When the battery power gets below 30%, the Warm White & Amber
LED's will alternately flash rapidly for 5 seconds each time the power
is switched ON. After the 5 seconds, the unit will function normally.
This is a warning letting you know that you must charge the unit soon.

Battery Recharge:

To recharge the battery, plug the supplied DC power supply into the
DC input located on the rear of the unit and plug the other end into a
matching power supply. It takes about 4.5 hours to reach full charge
with the power switch off.

Operating Power:

There are two ways to supply power to this unit; battery power or DC
power.
• DC Power - To run the unit using DC power, plug the unit into a DC
power source, and put the POWER switch into the ON position.
• Battery Power - To run the unit using Battery power, put the POWER
switch in the ON position.
ADJ Products, LLC - www.adj.com - PinPoint GO TW User Manual Page 7
Operating Instructions PinPoint GO TW
Mode Button Lock:
The MODE button will lock itself after 30 seconds if nothing is
pressed. To unlock the unit, press the MODE button for 3 sec-
onds.

Mode Operation:

Each press of the MODE button will cycle through the different oper-
ating modes. The operating modes are listed below in the order that
they appear. See the Color Temperature chart for a list of the different
color macros.
NOTE: When power is turned OFF and turned back ON, the unit
will start in the last operating mode.
Order of Operating Modes:
• Color Temperature Macros • Fast Fade • Fast Change • Slow Fade •
Slow Change
Pressing the MODE button again after Slow Change will return the
unit to the first color temperature setting. Starting the operating mode
order at the beginning.
PinPoint GO TW
Color # Color Temperature
1 2700K
2 3000K
3 3300K
4 3600K
5 3900K
6 4200K
7 4500K
8 4800K
9 5100K
10 5400K
11 5700K
12 6000K
ADJ Products, LLC - www.adj.com - PinPoint GO TW User Manual Page 8
Operating Instructions
Color Temperature Chart
CW WW Amber
11 255 255
91 255 255
114 225 255
227 255 255
255 255 134
255 255 44
255 208 0
255 130 0
255 80 0
255 46 0
255 21 0
255 0 0