Table of Contents
Advertisement
General Information
Service call indications
If there is an error that cannot be cleared by the user, the machine will show that a service call is needed by
lighting up all the LEDs as shown below.
If you see the service call indication shown above, turn off the machine, and then turn it back on and try to
print again.
If the error is not cleared after turning the machine off and then back on, press
as shown in the following table to identify the error. The number under the LED icon shows how many times
the LED will blink.
LED error indication
LEDs
Main PCB
failure
Error
Ready
(7)/(4)
1
If this error occurs, turn off the machine, wait a few seconds, and then turn it on again. Leave the machine for approx. 15 minutes with the power
on. If the error occurs again, call Fuji Xerox customer service or your local Fuji Xerox dealer.
For example, the LED indication below shows a fusing unit failure.
Make a note of the indication, referring to LED error indication on page 39, and report the error status to Fuji
Xerox customer service or your local Fuji Xerox dealer.
NOTE
Make sure that the top cover is completely closed before you report a service call.
Fusing unit
Laser unit
failure
1
failure
(3)
(5)
0.5 sec.
0.5 sec.
. The LEDs will light up
Main motor
High voltage
failure
failure
(6)
(2)
0.5 sec.
1 sec.
3
3
Zero Cross
error
(1)
39
Hide quick links:
Advertisement
Table of Contents
