Leak Test - Char-Broil Traditional 4638200 Assembly Manual

13
Connecting Grill to Natural Gas Source
1. Gas at line leading to grill must be shut off before connecting to
grill.
2. Attach gas supply tube to gas line. Wrench tighten.
s The appliance and its individual shut off valve must
be disconnected from the gas supply piping
system during
system at test pressures in
(3.5kPa).
s The appliance must be isolated from the gas supply
piping sustem by closing its individual manual
shutoff valve during any pressure testing of
the gas supply
pressures equal to or less than
1/2 psi (3.5 kPa).
14

Leak Test

Do not smoke during leak test.
Do not use an open flame to check for gas leaks.
Grill must be leak tested outdoors in well-
ventilated area, away from ignition sources such
as gas fired or electrical appliances. During leak
test, keep grill away from open flames or sparks.
Never remove opening at end of valve (A).
Use a clean paint brush and 50/50 soap and
water solution.
Damage to gas train components can result.
Check to make sure grill is connected to natural gas source and gas
supply is turned on.
Brush soapy solution onto following connections:
• Gas Supply Tube/Pipe (1) and all connections
• Valve (2) behind console
• Gas supply tube and connection (3)
bubbles appear, there is a leak. Turn gas off at control
knobs and gas source immediately. Retighten connections and
repeat leak test procedures. If leaks cannot be stopped, replace
parts. To order new parts call
1-800-993-2677.
any pressure testing of that
excess of 1/2 psig
piping system at test
s
• Do not use grill until leak checked.
• If leak is detected at any time, STOP and correct before using grill
further.
2
Connection from gas source
Gas Supply Tube
at back of grill
A
2
1
After connecting grill to
gas line, perform leak test
3
4638200 • 9