WAFER GSM-KEY-ADC200 User Manual page 14

Unit Time;
Unit Password:
Reception:
Battery backup:
Self clock update SMS: That is used to setup the phone number that is used to update the clock
Band selection:
Relay Mode:
Relay Status:
Alarm:
Alarm content:
Note:
1. Gate delay cann't be setup to "0", then when you call the device, that relay output would not
work.
2. You shouldnot change the BAND selection if you are not very familiar with the GSM device,
that would cause the function to stop to work
3. You can use the Relay Status selection box to check if that relay output can work well or not.
4. Battery backup function is not available on the normal Wafer products.
That is used to setting the timer of the GSM-KEY Device
That is used to change the control password
That is used to test the GSM signal quality of the site
That is used to setup the Power off alarm when power off.
Not available
That is used to setup the working mode
That is used to test the device through ON or OFF the on board relay
That is used to setup the alarm mode of the two alarm channel
That is used to setup the alarm SMS content.
WAFER GSM-KEY REMOTE CONTROL UNIT
http://www.waferstar.com