Immersing The Robot; Starting Up - Zodiac Sweepy M3 User Manual

How to use your Sweepy M3

1. Immersing the robot

IMPORTANT : Do not allow any bathing while your Sweepy M3
• We advise you to place the robot in a corner at the shallow end and position it so that it will start
moving across the width of the pool. The cable should be positioned towards the middle of the pool
(Fig. 7).
• Push the robot down into the water and evacuate the air it contains by turning it over if necessary.
• Use your hands to press on the foam brushes to push out the air and take in water.
This step is unnecessary for rubber brushes.
• It is essential that the appliance goes down by itself and rests on the bottom of the pool.

2. Starting Up

You can choose whether to operate your Sweepy M3
Whichever mode you choose the robot will operate for a period of time pre-set in the factory :
- 1 and a half hours for models fitted with a 16 m cable ;
- 3 hours for models fitted with a 25 m cable.
a) Automatic operation
In this mode your robot will perform a sequence of movements which have been programmed in the
factory to meet the requirements of most pools.
If this configuration does not suit the size or shape of your pool, contact your retailer so that he can
select the most suitable program for your pool.
• Set the rocker switch «manual / automatic mode» on the control box to «automatic» mode (Fig. 6).
• Set the «I/O» rocker switch to «I».
• Press the «Start» button to start the appliance.
• You can change to manual control of the robot's movement at any time by setting the switch to
manual mode.
• When the programme has been completed, the robot stops. Set the «I/O» switch to «O» and dis-
connect the supply lead from the mains.
IMPORTANT : Wait for about 1/4 hour before taking the robot out of the water.
™ in automatic or manual mode.
17
™ ?
2
™ is in the pool.