Remote Operation; Remote Access Code; Changing The Access Code - Memorex MPH2430 Operating Instructions Manual

MPH2430.O/M.QXD 1/29/03

REMOTE ACCESS CODE

This unit can be operated remotely from almost any touch-tone phone. The Access
Code is preset as shown below:
PRIMARY: 999
MAILBOX 1: 555
If the RESET button is pressed, the Access Codes will return to their default settings.

CHANGING THE ACCESS CODE

All digits of the Access Code are a combination of numbers 5, 6, 7, 8, 9, 0. Digits 1, 2, 3
and 4 cannot be used when changing the Access Code. You can operate the unit
remotely with the default codes, but we suggest you set your own new code. To
change this code, follow the instructions below:
1
Press a Mailbox button; the correspond-
ing mailbox indicator will blink.
Skip this step if you would like to
change the Access Code for the primary
mailbox.
3
Press and release the DAY button; the
corresponding number will be displayed
and announced. Press and release the
DAY button repeatedly until the desired
first digit of the Access Code is
displayed and mentioned.
NOTE: If your new Access Code is the same as another mailbox, the system will
not record your new code and announce, "Please try again."
9:12 AM Page 43

REMOTE OPERATION

MAILBOX 2: 666
MAILBOX 3: 777
2
Press and hold the CODE button; the
unit will announce, "Your password is
xxx, please enter new password".
Release the CODE button.
4
Repeatedly press the HOUR button
to set the second digit and the MIN
button
the CODE button
Access Code will be announced.
43
MAILBOX 4: 888
2
3
to set the third digit. Press
again; the new