Installation Instructions - Memorex MPH2430 Operating Instructions Manual

Cordless telephone with digital answering machine

Hide thumbs

Table Of Contents

Table of Contents

MPH2430.O/M.QXD

1/29/03

1. Carefully unpack and remove your unit from the box.

2. Make sure all of the following items have been included:

•

Base Unit

•

Handset Unit

•

Rechargeable Ni-Cd Battery Pack

(3.6V, 600mAH)

3. Make sure the Rechargeable Battery is installed or install the Rechargeable

Battery as described on page 10.

PLEASE REFER TO FIGURE 1 FOR STEPS 4 THROUGH 7:

DC 9V Jack

Adaptor Plug

4. Slide the TONE/PULSE switch on the side of the Base unit to TONE or PULSE

to match the service provided on your telephone line. If you are not sure of your

service, please contact your telephone company. The factory preset position for

this switch is TONE.

5. Connect one end of the telephone line cord into the TEL LINE jack on the rear

of the base unit and the other end into a modular telephone jack.

6. Insert the small plug at the end of the AC adapter into the DC 9V jack located at

the rear of the base unit.

NOTE: Use only the center-positive 9V AC adapter provided with your unit.

7. Plug the AC adapter into a standard 120V AC wall outlet.

8. If desired, install the belt clip by inserting the belt clip

hook into the matching slots at the top side of the

handset as shown in figure 2. Slide the other hook until

it locks into place from the opposite side of the

handset.

9:11 AM

Page 7