Troubleshooting - Haier HDBC100AFS User Manual

CLEANING THE FILTERS
1
Open
Step 1. Turn the filter in a counterclockwise direction then lift it up.
Step 2. Lift the Main filter up
Step 3. Lift the Fine filter up
NOTE: Reverse steps 1 through 3 to replace the filter.

TROUBLESHOOTING

Try the solutions suggested here first and possibly avoid the cost of a service call...
DISHWASHER IS NOT OPERATING PROPERLY
•
Dishwasher does not run or stops during a cycle
It is normal for most cycles to pause for 5 minutes near the start of a cycle to let
the dishes soak. This reduces energy required to clean the dishes.
Is the door closed tightly and latched?
Is the right cycle selected? Refer to the Cycle Selection charts.
Is there power to the dishwasher? Has a household fuse blown or circuit breaker
tripped?
Has the motor stopped due to an overload? The motor automatically resets
itself within a few minutes. If it does not restart, call for service.
Is the water shut-off valve (If installed) turned on? It is normal for certain cycles
to repeatedly pause for 15 to 65 seconds during the main wash.
•
Dishwasher will not fill
Is the overfill protection float able to move up and down freely? Press down to
release.
•
Dishwasher seems to run too long
Is the water supplied to the dishwasher hot enough? The dishwasher runs longer
while heating water. Refer to the "Dishwasher Performance Tips" section. A
delay automatically occurs in some wash and rinse cycles until the water reaches
the proper temperature.
2
3
21