Loading Silverware Basket - Haier HDBC100AFS User Manual

LOADING SILVERWARE BASKET

Load the silverware basket while it is in the bottom rack
or remove the basket and place on a counter or table for
loading. (See recommended loading pattern shown.)
NOTE: Unload or remove the basket before unloading
the racks to avoid water drops from falling on the
silverware.
•
Load items with handles down, using the separators
to prevent silverware nesting
•
Place small items such as baby bottle caps, jar lids,
corncob holders, etc. in the section(s) with hinged
cover(s). Close the cover to hold small items in place.
When handles are up, mix items
in each section of the basket
with some pointing up and some
down to avoid nesting. Spray
cannot reach nested items.
IMPORTANT: Always load sharp
items (knives, skewers, etc.)
pointing down. Be sure that
nothing protrudes through
bottom of the basket or rack
that may block the wash arm.
NOTES:
•
Do not load silver or silver-
plated silverware with
stainless steel. These metals
can be damaged by contact
with each other during
washing.
•
Some foods (such as salt,
vinegar, milk products,
fruit juices, etc.), can pit
or corrode silverware. Run
a rinse cycle if you do not
have a full load to wash
immediately.
10
Mixed load
2 4 5 1
4 5 1
2 4 5 1
1. Salad Forks
2 4 5 1
2. Teaspoons
4 5 1
3. Soup Spoons
2 4 5 4
4. Dinner Forks
2 4 5 7
5. Knife
3 5 6. Serving Spoon
7. Serving Fork
2 3 3 1
2 3 3 1
3 3 1
2 3 6 6