Initialization; Clearing A Machine Lock Up - Casio SE-C300 Dealer's Manual

Initialization (SE-C300 / SE-C2000)
• Automatic initialization
Use the following procedure to initialize the cash register before using it for the first time after you purchase it.
1. Install the two memory backup batteries (see page 10 of the User's Manual).
2. Plug the cash register into a wall outlet.
• At this time, "0000000000" appears on the display and the printer operates for a minite. Initialization is complete when the printer stops
operating.
CAUTION!
Automatic initialization (which clears all sales and programming data stored in the register's memory) is performed
whenever all power (both the backup batteries and power through power cord) is cut from the cash register and then
restored. The program data stored in the flash memory is restored.
Remember...
Main power cut by:
• Unplugging the cash register
• Power failure
• Manual initialization
Use the following procedure to initialize the cash register and clear all transaction data and program data from its memory.
1. Insert the mode key marked "PGM" into the mode switch.
2. Turn the mode switch to the OFF position.
3. While holding down the
f
4. Release the (SE-C300)
: : : : : ;
5. Enter
A B C
*1) In case of Arabic character is used,
; : ; ; ; ; ; ; : : : : : ;
enter
5
*2) A,B,C,D: refer to the following.
A. Language selection
This specification defines the
language to use for the date in
receipt/journal printing.
2
0
English
2
1
French
2
2
Spanish
2
4
German

Clearing a machine lock up

If you make a mistake in opreation, the cash register may lock up to avoid damage to programs and preset data.
Should it happens, you can use the following procedure to clear the lock up without losing any data.
1. Power off the register.
2. Insert the PGM key in the mode switch.
f
3. Press down and hold
4. The display shows INIT(SE-C300) / FC (SE-C2000) on alpha-display, then release
s
5. Press . A receipt is issued.
Backup power cut off by:
+ • Removing the batteries
• Dead or low batteries
f j
(SE-C300) (SE-C2000) key, turn the mode switch to the PGM position.
j
(SE-C2000) key.
and press the
D
B. Area / monetary mode
This specification defines the
area and the decimal position.
German
Two decimal place 2
No decimal place 2
f
(SE-C300) (SE-C2000), and turn the mode switch to PGM mode.
s
key. *1), *2)
A B C D
C. Touch keyboard
This specification defines touch
keyboard with deparment or
flat-PLU.
Department keys are allocated
2
4
1
3 Flat PLU keys are allocated
Automatic initialization when
= the main power is restored and
the mode switch is set to any
position besides OFF.
s
and press the key.
D. System selection
and Program 4 mode
This specification defines
System selection and
Program 4 mode availability.
-Normal system *1-
2
72
w/o PGM 4 2
with PGM 4 2
2
00
-Check Tracking System *2-
w/o PGM 4 2
with PGM 4 2
f f
(SE-C300) (SE-C2000).
0
4
2
6
3