Initialization (For Se-S400/Se-S3000); Initializing The Cash Register; Automatic Initialization; Manual Initialization - Casio SE-S3000 Dealer's Manual

Initialization (for SE-S400/SE-S3000)

Initializing the cash register

Automatic initialization

Use the following procedure to initialize the cash register before using it for the first time after you purchase it.
1. Install the two memory backup batteries.
2. Plug the cash register into a wall outlet.
3. Read the printouts and follow the procedure printed on the chit. Select the country and language from
the list then press a key. If you want to skip this step, just press s key.
4. Follow the procedure on the display to set the date and time.
• At this time, "00000000" appears on the display and the printer operates for a minute. Initialization is
complete when the printer stops operating.
CAUTION!
Automatic initialization (which clears all sales and programming data stored in the register's memory)
is performed whenever all power (both the backup batteries and power through power cord) is cut
from the cash register and then restored. The program data stored in the flash memory is restored.
Remember...
Main power cut by:
• Unplugging the cash register
• Power failure

Manual initialization

Use the following procedure to initialize the cash register and clear all transaction data and program data
from its memory.
1. Insert the mode key marked "PGM" into the mode switch.
2. Turn the mode switch to the OFF position.
3. While holding down the f (SE-S400) j (SE-S3000) key, turn the mode switch to the PGM position.
4. Release the f (SE-S400) j (SE-S3000) key.
5. Enter
A B C D E
A. Language selection
B. Area/monetary mode This specification defines the area and
C. Department number This specification defines the number of
D. Program 4 mode
E. Number of PLU
Backup power cut off by:
+
• Removing the batteries
• Dead or low batteries
and press the s key. (A, B, C, D: Refer to the section below.)
This specification defines the language
to use in receipt/journal printing.
the decimal position.
department keys.
This specification defines Program 4
mode availability.
This specification defines number of
PLUs.
Automatic initialization when the
=
main power is restored and the
mode switch is set to any position
besides OFF.
English French
0
2
Dutch German
3
2
Danish Norwegian 2
6
2
Portuguese 2
9
German
Two decimal place
No decimal place
SE-S400
SE-S3000
w/o PGM4
with PGM4
PLU 3000/Scanning PLU 2000 2
PLU 2000/Scanning PLU 3000 2
(SE-S400 only)
Spanish 2
1 2
2
Swedish 2
4 5
2
Finnish 2
7 8
4
2
1
2
3
2
25
2
30
2
0
2
4
2
0
2
3