Machine Initialization - Casio TE-3000S Service Manual

3. MACHINE INTIALIZATION
Machine initialization procedure
Note: If your register has the clerk lock, be sure to pull out the clerk key.
1. Plug the power cord into an AC outlet.
2. Set the mode switch to OFF position.
3. While holding down
4. Release
You should see "0000000000" on the display.
If 10 zeros are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Enter 11-digit program code from the worksheet.
6. Press to register the program code.
(Wait until beep twice.)
7. In case of installing inline system,
enter 3-digit program code from the worksheet.
(For TK-6000/6500 without inline option, do NOT enter any value.)
8. Press to register the program code.
Please turn on and initialize the register in order, if your registers are connected with inline.
The ID number of registers are defined automatically.
(Do NOT turn off the register(s) until all register has been initialized.)
, set the mode switch to PGM.
.
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
D D
11 10
(refer to Initialize 1)
(refer to Initialize 2)
After completion of initialization and program
loading, initialization receipt is issued.
— 5 —
REG2 X1
REG1
RECEIPT
FEED
OFF
RF
PGM
RECEIPT JOURNAL
FEED FEED
D D ~ D D D
9 8 3 2 1
D D D
3 2 1
Z1
X2/Z2