Placing Out Of Action - Quick MILL 04003 Operating Instructions Manual

Mod. 04003 / 04004
Carefully follow the instruction on the
descaling products' packaging. For information
concerning the choice of the cleaning product,
contact the retailer.
Clean the water tank 10 making sure to place the
rubber tube with the filter until it reaches the bottom
of the tank.

11. PLACING OUT OF ACTION

11.1. Temporary
Empty the water tank 10 and the drip tray.
Switch all the switches off and disconnect the cable
from the plug.
Carry out the necessary maintenance operations.
Place the machine in a dry place, away from
atmospheric agents and of exclusive access (avoid
leaving it in the reach of children or untrained
persons).
11.2. Definitive
Do the following in addition to the "Temporarily placing
out of service" actions:
Cut the power cable;
Wrap cardboard or other material around the machine
and cosign to the authorized personnel (authorized
refuse disposal center or used material collection
center).
12. POSSIBLE PROBLEMS
In the event of damage to the power supply
cable, contact an authorized service company
for replacement as a special tool is required.
The scrap material used for processing or maintenance
should be placed in containers and sent to special
collection centers, unless they are biodegradable or non-
polluting.
Operations to be carried out by the user after
disconnecting the electrical supply.
A) The machine fails to start:
- Check whether the power plug is connected:
- Check that the power is on and that the ground-fault
interrupt or the main switch is engaged;
- Check the conditions of the plug and the power cable,
should they be damaged have them replaced by
authorized personnel;
- Check the fuses in the machine plug.
B) Machine fails to deliver coffee:
- Lack of water in the tank; fill it in.
- The boiler has not been refilled.
- Overheated coffee pump: wait for the restart of the
thermal protector.
C) Machine fails to deliver hot water or steam:
- Lack of water in the tank; fill it in.
- Overheated hot water / steam pump: wait for the restart
of the thermal protector.
- Clogged nozzle: clean the steam delivery nozzle.
E) Irregular coffee brewing:
- Rinse the filterholder.
- Check that the grind is neither too coarse nor too fine.
In the event of all problems not specified always
detach the power cable, avoid undertaking any
further diagnostic operations or direct repair, and
contact the retailer or a qualified service company.
Rev. 01
13
13