Installation - Quick MILL 04003 Operating Instructions Manual

Mod. 04003 / 04004
The packaging elements (plastic bags, injected
foam, nails, cardboard, etc.) must not be left
within reach of children as they are potential
sources of danger.
Do not dispose of the packing elements in the
environment; cosign them to firms authorized for their
disposal.

8. INSTALLATION

The machine is delivered ready to be installed in
accordance to the label data.
Ensure that the electrical supply system has the same
features as the machine.
The electrical supply system must be equipped with a
ground-fault interrupt with a general automatic switch
with an efficient grounding system. Should there be no
electrical protection element, have a single-pole switch
installed by qualified personnel, as outlined by the
current safety regulations.
The grounding
mandatory.
The manufacturer declines all responsibility
in the event of failure to respect the accident
prevention norms.
Take care not to damage the supplied cable with wraps,
or press.
Do not disconnect the machine by pulling the cable, but
instead by gripping the plug.
In order to prevent problems relating to operation,
supply and maintenance, the machine is not to be placed
in any recesses or similar difficult positions.
The machine must be placed on a completely level
surface, that is both dry and sufficiently stable and at
a height of 80 cm from the ground;
Position the machine and connect the plug to the power
outlet.
8.1. Control description
1. Main power switch.
By pressing this switch, the machine is powered
(green light 5 on) and the heating of water in the
boiler is activated (light 6 and 7 on).
2. Coffee brewing switch.
By pressing this switch, the coffee brewing starts.
3. Hot water supply switch.
By pressing this switch, the hot water is supplied
through the wand 8.
4. Steam supply switch.
By pressing this switch, steam is supplied through the
wand 8.
NOTE: Switches 3 and 4 must be used
separately (water cannot be taken at the same
time as steam or vice versa).
6. Boiler resistance light.
of the appliance is
The light gets on when the boiler water is being
heated through the heating element.
8. Heat-exchanger resistance light.
The light gets on when the heating element in the
heat-exchanger is activated.
9. FUNCTION
9.1 Filling
For the first time and for refilling (always switch off the
machine):
Fill the water tank (use drinking water, softened if
possible).
Fill the water tank before using the machine the first
time, after a long period of inactivity or when the tank is
empty.
The machine is provided with 2 lime filter with resins:
before switching the machine on, keep the filters in
water so that resins get socked with water.
Insert the water tank making sure that the rubber pipes
are not bent.
Remove the Filterholder, then press the main switch 1
and the switch 2 for coffee brewing at the same time.
When water comes out of the brew head, switch off the
coffee brewing button.
If water fails to come out after 30 seconds, repeat the
operation.
Insert the filterholder 13 and wait until the machine
heats up and reaches the correct temperature.
9.2 Machine heating
Control the level of water in the tank.
Press switch 1 (light 5 on)
Wait until the machine reaches working temperature
(lights 6 and 7 off).
When using the machine for the first time, allow
about half liter of water to go through the
machine in order to rinse the group by pressing
the switch for coffee brewing and the one for hot
water supply to rinse the circuit of the heat-
exchanger.
Rev. 01
11
11