Quick MILL 04003 Operating Instructions Manual page 10

Mod. 04003 / 04004
Features on identification plate:
1 Manufacturer
2 Model
3 Voltage
4 Electrical frequency
5 identification number
6 Year of manufacture
7 Total machine power
8 Compliance marks
PREMISE
Keep this handbook in a safe place. For further
information or problems, please address to
competent personnel.
1. SYMBOLS
The warning triangle identifies all the important
explanations for personal safety.
Pay attention to these warnings to
prevent accidents!
The numeric symbols or letters indicate
references to illustrations and parts of the
2
machine like keys, warning lights, etc...
The manufacturer shall not be held liable
for any injury or damage caused by:
• Uses not in compliance with foreseen
purposes;
• Alteration of the cord;
• Alteration of any component of the machine;
• The use of components or accessories which
are not original;
• Repairs not made by authorized service
centers.
This product complies with the WEEE
Directive (2002/06/EC)
requirements. The affixed label indicated that
you must not discard this electrical /
electronic product in domestic household
waste.
PRODUCT CATEGORY: with reference to
the equipment types in the WEEE Directive
Annex I, this product is classed as category 2
"Small electric
product.
DO NOT DISPOSE
HOUSEHOLS WASTE.
Failure to observe the above points shall result
in forfeiture of the warranty.
marking
household appliances"
IN DOMESTIC
2. WARNINGS
Keep the packaging (plastic bags, injected foam,
cartons, etc...) out of the reach of children, as they
can be potentially dangerous.
Before connecting the machine, make sure the features
on the plate correspond to the electricity voltage.
The cord should be well unwounded (avoid any wrap
or overlap), not exposed to hitting or children
tampering. It must be away from fluids, water or
heating sources; it must not be damaged (in case,
make it replace by qualified personnel).
It is inadvisable to use adaptor, multiple plugs and / or
extension cable. In case of necessity, use quality
certified products (like IMQ, VDE, +s, etc....) and
check that the voltage capacity limit indicated on the
adapters exceeds the absorption capacity (A =
ampere) of the equipment.
When in doubt, request an accurate check of the
connections by qualified personnel. The wiring system
must comply with the following safety regulations:
- Efficient grounding;
- Section of conductors suitable for absorbtion
capacity;
- Efficient earth leakage protection circuit breaker.
Place the machine on a water-repellent top (laminate,
steel, ceramic, etc.) away from heat sources (oven,
cooking stoves, fireplace, etc.) and in conditions in
which the temperature may not go below 5°C.
Do not leave the machine exposed to atmospheric
agents (rain, sun, etc.) and do not install in damp
rooms such as bathrooms.
In the event of parts replacement, request original
spare from an authorized retailer or dealer.
Keep the packed machine in a dry place, not exposed
to atmospheric agents and in conditions in which the
temperature will fall below 5°C.
Do not stack more than four items of the same kind. Do
not place heavy items on the packaging.
Erroneous installation may cause damage to
people and things for which the manufacturer
cannot be considered responsible.
Rev. 01
9
9