Sub-Zero IC-27R Installation Manual page 10

Site Preparation
Anti-Tip Bracket Installation
To prevent the unit from tipping forward and provide
a stable installation, the unit must be secured in place
with the anti-tip bracket provided with the unit.
An anti-tip bracket and hardware is provided with the inte-
grated unit. Placement of the anti-tip bracket is critical to
a stable installation. The anti-tip bracket must be installed
on a solid base.
If you are installing the unit in a space deeper than 24"
, be sure to locate the anti-tip bracket so that it
(610)
engages the unit properly. It is important that the anti-tip
bracket is placed 24"
(610)
(without panels) to the back of the anti-tip bracket.
IMPORTANT NOTE: In some installations the subflooring
or finished floor may require angling the wood screws
used to fasten the anti-tip bracket to the back wall.
Make sure there are no electrical wires or plumbing
in the area which the screws could penetrate.
from the front of the unit
WOOD FLOOR APPLICATIONS
1
Use the six #12 x 2 / " wood screws and the six
2
washers provided. Drill pilot holes
maximum, and make sure the screws penetrate through
the flooring material and into the wall plate a minimum of
3
/ " . Make sure the screws hold tight. Refer to the
(19)
4
illustration below.
CONCRETE FLOOR APPLICATIONS
3 3
Use the two / " x 3 / " concrete wedge anchors, two
8 4
1
#12 x 2 / " wood screws and two
2
provided. Make sure the anchors and screws hold tight.
Refer to the illustration below.
Anti-Tip Bracket Placement
27" Models
(686)
36" Models
(914)
A
A
FINISHED
FLOORING
WALL PLATE
SUBFLOORING
WOOD FLOOR
Wood floor.
1
/ " flat
4
3
/ " diameter
(5)
16
1
/ " flat washers
4
13 1 / "
(343)
2
18"
(457)
A
A
FINISHED
FLOORING
WALL PLATE
SUBFLOORING
1 1 / "
2 (38)
CONCRETE
min
FLOOR
Concrete floor.
10
A