Dual Installations - Sub-Zero IC-27R Installation Manual

Integrated Installation

Dual Installations

Two integrated units may be placed side by side in a dual
installation. Panel width dimensions will vary slightly from
single installations. A dual installation kit is required for
installations with 2"
(51)
Dual installation kits are available through your authorized
Sub-Zero dealer.
IMPORTANT NOTE: If a 27"
36" tall model, the decorative front panels will align,
(914)
however, the face frames will not. This is only apparent
when both doors are open at the same time. Due to a
more robust hinge on 36"
reconfigured to maintain a consistent overall panel height.
Typical Panel Dimensions
COLUMN MODELS
Door
27" MODELS
(686)
Door
Top Drawer
Bottom Drawer
36" MODELS
(914)
Door
Top Drawer
Bottom Drawer
or less space between units.
unit is installed next to a
(686)
units, the face frame was
(914)
W
26 13 / " 76
(681)
16
W
26 13 / " 45
(681)
16
13
26 / " 13
(681)
16
26 13 / " 16
(681)
16
W
35 13 / " 45
(910)
16
35 13 / " 13
(910)
16
35 13 / " 16
(910)
16
90° Door Stop
The door of integrated columns and tall models opens
to 105°. A 90° door stop is built into the hinge system for
installations where the door opening must be limited.
To engage the door stop, use the blade edge of a
standard screwdriver and rotate the cam in the center
portion of the hinge. You must make this adjustment to
both the bottom and top hinge. Refer to the illustration
below.
H
7 / "
(1953)
8
H
3 / "
(1153)
8
9
/ "
(345)
16
11 / "
(424)
16
H
3 / "
(1153)
8
9 / "
(345)
90° door stop.
16
11 / "
(424)
16
20