Table of Contents
Advertisement
J. DRAM installing
System Memory
The left edge of the Onyx-151 MAIN BOARD contains a socket for
168-pin dual inline memory module (DIMM). The socket uses 3.3 V
unbuffered synchronous DRAM (SDRAM). DIMM is available in
capacities of 16, 32, 64, or 128 MB. The socket can be filled in the
DIMM of any size, giving your Onyx-151 MAIN BOARD between 16
and 128 MB of memory.
Supplementary information about DIMM
Your Onyx-151 MAIN BOARD can accept both regular and PC-100
SDRAM DIMM Module(with or without parity). However, if the
Pentium II 350MHz or up CPU is used, The Onyx-151 MAIN BOARD
can only accept PC-100 SDRAM DIMM Module. Single-sided modules
are typically 16 or 64 MB; double-sided modules are usually 32 or
128 MB.
Memory Installation Procedures
To install DIMM, first make sure the two handles of the DIMM
socket are in the open" position. i.e. The handles remain outward.
Slowly slide the DIMM module along the plastic guides on both
ends of the socket. Then press the DIMM module right down into
the socket, until you hear a click. This is when the two handles
Onyx-151 Quick Installation Guide
10
Advertisement
Table of Contents
