Removing and installing the support bracket
When working with some devices, such as hard disk drives, adapters, and memory
modules, you must first remove the support bracket to access the device.
Complete the following steps to remove the support bracket:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Remove the side cover (see "Removing the side cover" on page 15).
3. Pull out on the rear end of the support bracket at a 45° angle.
4. Disengage the front end of the support bracket from the server and set the
To reinstall the support bracket, reverse the previous steps.
on page 13.
bracket aside.
Chapter 2. Installing options
17