Table of Contents
Advertisement
6. If you are installing additional hot-swap hard disk drives, do so now.
7. Slide the drive-bay lock bar to the right.
8. If you have other options to install or remove, do so now; otherwise go to
26
xSeries 206 Type 8482: Installation Guide
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status indicator to make sure that the hard disk
drive is operating properly. (You might have to restart the server before the
drive is recognized.) If the amber hard disk drive status LED for a drive is lit
continuously, it indicates that the drive is faulty and must to be replaced. If
the green hard disk drive activity LED is flashing, this indicates that the drive
is being accessed.
Note: If your server is configured for RAID operation using an optional
™
ServeRAID
arrays after installing hard disk drives. See the ServeRAID
documentation on the IBM ServeRAID Support CD for additional
information about RAID operation and complete instructions for using
ServeRAID Manager.
"Completing the installation" on page 38.
Drive bay
lock-bar
controller, you might have to reconfigure your disk
Filler panel
Drive tray
assembly
Drive tray handle
(in open position)
Advertisement
Table of Contents
