Manual Dubbing (From Vcr To Dvd) - JVC DR-MV1S Instructions Manual

EDITING
66
EN

Manual Dubbing (From VCR To DVD)

Dubbing A Part Of A Cassette
You can dub the selected scenes on a tape to the DVD disc,
starting and stopping wherever you wish.
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
VCR/DVD
VCR/DVD
3
8
REC MODE
9 5
4
8 73
SAT
1 2 3
4 5 6
7 8 9
0
4
5
9
7
1
For DVD deck
Load a recordable disc.
For VCR deck
Load a cassette you want to dub.
2
Press VCR] to select the dubbing direction.
● "VCR]" lights up on the front display panel.
3
Prepare the VCR deck for dubbing.
A Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
B Locate the point from where you want to start dubbing, then
pause playback by pressing the following buttons: 4, 5, 3,
VCR ]
8, 9
4
Prepare the DVD deck for dubbing.
A Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
B Press REC MODE repeatedly to set the recording mode.
C Press and hold 9, then press 7 so that the DVD deck enters
the Record Pause mode.
5
Press and hold DUB for more than 2 seconds to start dubbing.
DUB
6
Press 8 to stop recording on the DVD deck. Then press VCR/
DVD, and press 8 to stop playback on the VCR deck.
NOTES:
● If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to dub. It is recommended to
conduct a test with unimportant cassettes first.
● There may be a discrepancy of several seconds between where you
intend dubbing to start, and where it actually stars.
● The superimposed indication during the operation or dubbing is not
recorded.
● It is not possible to dub a tape with a copy protection signal.
● If the recording capacity of disc become full, the tape stops
automatically.
● It is not possible to perform other operations like Live Memory
Playback. Check the recorded programme on the disc after dubbing.
● Dubbing is not possible on the discs used exclusively for On-Disc
Timer Programming.