Table of Contents
Advertisement
Changing the needle
1.
Use the hole in the multi-purpose tool to hold
the needle.
2.
Loosen the needle screw.
3.
Remove the needle.
4.
Insert the new needle, using the multi-purpose
side away from you until it will go no further.
5.
Tighten the needle screw as tight as it will go.
USB ports
Your machine has two USB ports – one to connect
the sewing machine to your computer, and one to
connect either your USB embroidery stick, optional
USB hub or optional mouse.
Note: Make sure that the USB stick you use has the
format FAT32.
USB embroidery stick
Delivered with your machine is a USB embroidery
machine.
Connect to and remove from USB port
Insert the USB embroidery stick or other devices in
the upper port. The USB plugs can only be inserted
one way – do not force them into the ports!
The USB PC cable packed with your machine
(P/N:412 62 59-04) plugs in to the lower port. No
other cable should be used in this port. Connect the
other end of the cable to your PC.
Note: Install the complimentary software before
connecting the machine to your PC (see next page).
To remove, carefully pull the USB embroidery stick
or the plug of the USB cable out straight.
Using the USB embroidery stick
When loading from or saving to the USB
embroidery stick an hourglass appears on the
screen.
Note: Do not remove the USB embroidery stick when the
hourglass is shown on the screen or while Files & Folders
is open. Removing the stick at that time can damage the
Note: The USB embroidery stick provided
with the machine can be left in the machine
when putting on the hard cover. Make sure
that the cover of the USB stick is turned
downwards.
2:11
Advertisement
Table of Contents
