Panasonic CS-E9RKUAW Service Manual page 37

11.2.5 Wiring Stripping and connecting requirement
No loose strand
when inserted
WARNING
Do not joint wires
11.2.5.1 Cutting and flaring the piping
1 Please cut using pipe cutter and then remove the burrs.
2 Remove the burrs by using reamer. If burrs are not removed, gas leakage may be caused. Turn the piping
end down to avoid the metal powder entering the pipe.
3 Please make flare after inserting the flare nut onto the copper pipes.
Point down
1. To cut
2. To remove burrs
Wire stripping
RISK OF FIRE
JOINING OF WIRES
MAY CAUSE
OVERHEATING
AND FIRE.
OR
Pipe
Reamer
Bar
Clamp handle
3. To flare
Indoor/outdoor
connection
terminal board
7 / "
(5 mm)
32
or more
(gap between wires)
OR
0 –
Handle
(0-0.5 mm)
Bar
Yoke
Core
Copper
Red arrow mark
pipe
37
Conductor Conductor
fully inserted over inserted
ACCEPT PROHIBITED
OR
Use complete wire without joining.
Use approved socket and plug with earth pin.
Wire connection in this area must follow to
national wiring rules.
Improper flaring
1
/ "
32
Inclined Surface Cracked Uneven
damaged
When properly flared, the internal surface of the
flare will evenly shine and be of even thickness.
Since the flare part comes into contact with the
connections, carefully check the flare finish.
Conductor not
fully inserted
PROHIBITED
thickness