GE AMD10 Use And Care & Installation Manual page 7

Hide thumbs Also See for AMD10:
Table of Contents

Advertisement

Keep the air filter clean.
For most efficient cooling,
keep the ventilation control in
the CLOSE position except
when you want to exhaust air,
smoke or odors from the room.
Don' t let the room get too
hot. Whenever possible, turn the
unit on before the room heats up.
When heat is "stored up" in walls,
furniture, rugs and draperies, your
air conditioner takes longer to
produce the desired comfort
condition.
Keep windows and doors
closed. Cool, dry air escapes
when they're open.
Keep furnace floor registers and
cold air returns closed. Cold air
can easily escape through them.
Don't let drapes or furniture block
the top or front of unit and restrict
air flow when it is operating.
It's best to operate your air
conditioner at high speed during
extremely hot weather.
coil clean.
Turn air conditioner off before
vacations or extended absences
from home.
m
Questions
PROBLEM
AIR CONDITIONER
DOES NOT OPERATE
AIR CONDITIONER
"DOES NOT COOL
AS IT SHOULD"
OPERATING SOUNDS
WATER DRIPPING
OUTSIDE
WATER DRIPPING
INSIDE
WATER IN BASE PAN
(ON OUTDOOR SIDE)
If you need more help...call, toll free:
GE Answer Center@
800.626.2000
consumer information service
POSSIBLE CAUSE
Not plugged in. Plug may have been bumped
loose by vacuum cleaner or furniture.
If plugged in, fuse could have blown or
circuit breaker may have tripped.
Curtain, blinds or furniture blocking the top or
the front of the air conditioner will restrict airflow.
Move the knob to a higher number. Highest
setting should provide maximum cooling. When
Energy Saver Switch is set at SAVE, temperature
range in room will vary more.
Air filter dirty, should be cleaned at least
every 30 days.
Room may have been very hot when air
conditioner was first turned on. Allow time
for it to cool down.
Cold air may be escaping through open
furnace floor registers and cold air returns.
Ventilation control may be set at OPEN position,
allowing hot outside air to enter the room.
Cooling coils have iced up. To melt ice, move
the Selector Switch to FAN ONLY and the
Thermostat Control to a lower number.
Thermostat click, a metilic sound, may be heard
when compressor cycles on and off. This is normal.
Fan runs continuously when Selector Switch
is in COOL or FAN position. This is norrnd.
When Energy Saver Switch is set at SAVE, fan
cycles on and off with compressor.
Excess water may ovefflow in extremely hot
and humid weather. This is normal.
Air conditioner must be installed level or tilted
slightly to the outside for proper water disposd.
This is normrd for a short period in areas with
little humidity; normal for a longer period in
very humid areas. Moisture removed from
indoor air drains to rear of cabinet where it is
picked up by a fan and thrown against the
outdoor condenser coil.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Amd12Amh12

Table of Contents