GE AMD10 Use And Care & Installation Manual page 11

1. Slide left window filler panel into top and bottom
mounting rails.
2. Slide retainer panel into window filler panel and
attach to cabinet with 2 Type C screws.
3. Repeat for right side.
Window —
filler panel
' lNSmLL CABINETIN WINDOK
1. Cut sealing ribbon to window width and stick it
to bottom of the lower window sash.
2. Measure and mark center of window sill to
establish mounting position of cabinet.
3. Install cabinet into opening and center on line
marked on window sill. Put top of cabinet toward
you and lower window sash behind top mounting
Center line
4. Extend and secure left and right window filler
panels to window sash with Type A screws, one on
each side.
Top mounting rail
—
Retainer panel
Sealing
ribbon
(ADHESIVE
SIDE)
5.
Secure top mounting rail with two Type B screws.
Cut foam sash gasket to window width and stuff
between top of lower sash and glass panes of
upper sash. Make sure foam gasket is flush with
top of lower sash.
Install sash locking bracket using Type A screws.
Type A
screw
(continued next page)