Status Indication Table - RC Logger NovaX 350 Operating Instructions Manual

37. STATUS INDICATION TABLE

Type Status
Flight Mode Basic (ACC assisted)
Altitude (Midstick height hold)
GPS (position hold)
Flight agility
(Bank selection switch)
R.T.H. Return-to-Home
Flight Error Low battery level 1
Low battery level 2
Fail safe (PPM failed)
Flight Check Error GPS / compass failed
Pressure sensor failed
Gyro failed
Power system failed
(ESC/motor)
Permanent system check
Calibration Tx
Gyro
Compass
Tx
Gyro
Compass
Factory state Gyro or compass calibration procedure
46 | Status Indication Table
Trigger
Channel 5 : (+100)
Channel 5 : (0)
GPS fixed - No signal
GPS fixed - Poor signal
Channel 5 : (-100), strong GPS signal
Channel 6
Channel 5 triggered via switch or Transmitter (Tx) off
Battery <11.4 V
Battery <10.5 V
Loss of RF signal
Start up main board self test
System error (pilot must land!)
App or button on flight controller
App or button on flight controller
App or button on flight controller
Calibration in progress
Calibration in progress
Calibration in progress
Invalid gyro or compass calibration
Front LED
Magenta – Solid
Green – Solid
Blue – Blinks (fast)
Blue – Solid
Blue – Solid
No indication
White – Blinks continuously (0.5 Hz)
White – Blinks continuously (1 Hz)
White – Blinks continuously (5 Hz)
White – Blinks continuously (0.5 Hz)
Red – Blinks continuously (1 Hz)
Red – Blinks (fast)
Red – Solid/ Blue – Solid (small LED)
Green – Solid/ Blue – Solid (small LED)
Magenta – Solid/ Blue – Solid (small LED)
Red – Solid/ Blue – Blinks (small LED)
Green – Solid/ Blue – Blinks (small LED)
Magenta – Solid/ Blue – Blinks (small LED)
Cyan – Blinks 1Hz (alternating to rear)