Learning The Channels; Learning Procedure - RC Logger NovaX 350 Operating Instructions Manual

27.5 Learning the channels

You must reserve one 2-way-toggle-switch for the R.T.H.
(Return To Home) function. When R.T.H. is triggered it will
overwrite all settings of channel 5 (flight modes).
> A beep confirms a successfully learned channel.
> A blink code (e.g. 1 blink) indicates which channel is to be learned next.
> Auxiliary switch: Slowly move the switch through all positions and back to its starting
position.
> Assign a 3-position-toggle switch to channel 5 and channel 6.

27.5.1 Learning procedure

1. Carefully remove the canopy. Do not damage any component!
2. Turn the transmitter on and switch it to "H1 helicopter" mode (not applicable to
88014RC RtF).
3. Select a new model on your transmitter.
4. Connect the flight battery.
5. Switch to the channel learning procedure. Refer to
calibration' on page 28.
6. The front large RGB LED turns solid red. The front small blue LED (on front light panel)
indicates operational status (solid = not active, blinking = active).
7. Start the calibration procedure. The blue LED starts to blink. 88014RC RtF: Observe
'27.5.2 88014RC & 89102RC Auxiliary switch assignment' on page 31.
8. Learn the channels according to the following table. Pay attention to the LED blink
codes.
9. Complete the procedure.
30 | Calibration
'27.3 Switching between learning/
LED Control
3
2 4
MODE 1
1
1 Throttle, 2 Rudder, 3 Elevator, 4 Aileron
1 blink Throttle – Move to min. and back (mid-position) Ch 1 (mode-dependent)
2 blinks Rudder – Move to left and back
3 blinks Elevator – Move to top and back
4 blinks Aileron – Move to the left and back
5 blinks Flight mode selection switch (3 positions):
» Pos 1: GPS
» Pos 2: Altitude
» Pos 3: Basic
6 blinks Bank selection switch (3 positions):
» Pos 1: AP Mode
» Pos 2: Sport Mode
» Pos 3: Custom Mode (Set by pilot)
7 blinks Retractable legs (2 positions)
8 blinks Gimbal control (2 positions)
It is possible to complete the learning procedure after having
learned channel 6 by waiting for at least 8 seconds. When
using a 6-channel transmitter, a timeout function (8 seconds)
will automatically complete the learning.
Channel
3
2
4
MODE 2
1
Ch 2 (mode-dependent)
Ch 3 (mode-dependent)
Ch 4 (mode-dependent)
Ch 5
Ch 6
Ch 7
Ch 8