Futaba ® Transmitters Without 3-Way-Toggle-Switch; Calibrating The Gyro; Calibrating The Compass - RC Logger NovaX 350 Operating Instructions Manual

27.5.3.3 6-channel transmitters:
When using a 6-channel transmitter, trigger R.T.H. by turning the transmitter off.
Additionally, set channel 5 to +30 % in the 'fail safe' status. Refer to the user instructions
of your transmitter and receiver.
27.5.4 Futaba transmitters without 3-way-toggle-switch
®
In case you do not have a free 3-way toggle switch available on your transmitter, you may
assign a 2-way-toggle-switch instead and shift your channel END POINT after performing
the learning procedure on your transmitter. See [ Fig. 11 ].
> By default the END POINT for channel 5 (flight mode switch) is set to "135 100". This
default setting lets the 2-way-toggle-switch function as the bank selection switch (AP
mode, Sport mode).
> To toggle between these two modes instead, simply shift the END POINT to "0 100"
for the affected switch. See [ Fig. 11 ].
> You may use the same approach for channel 6 (AP, Sport and Custom mode).
LINKAGE MENU 1/2
SERVO : SUB-TRIM
MODEL SEL. : REVERSE
MODEL TYPE : FAIL SAFE
FREQUENCY : END POINT
FUNCTION : THR CUT
Fig. 11
32 | Calibration
END POINT 2/2
LIMIT
AUX1 0 100 6 100 135
AUX2 135 100 7 100 135
AUX3 135 100 8 100 135
AUX4 135 100 100 135

27.6 Calibrating the gyro

You MUST perform this step with precision or the »NovaX
350 won't fly properly.
1. Study [ Fig. 12 ].
2. Switch to the gyro calibration procedure. Refer to '27.3 Switching between learning/
calibration' on page 28.
3. Start the procedure.
4. Replace the canopy.
5. Place the »NovaX 350 on a horizontal and level surface [1] and wait for a single beep.
6. Rotate the »NovaX 350 by 180° about its vertical axis [2] [3] .
7. 2 beeps confirm the successful completion of the gyro calibration procedure.
8. Remove the canopy.
9. Complete the procedure.

27.7 Calibrating the compass

You MUST perform this step with precision or the
»NovaX 350 won't fly properly. Perform the compass
calibration in an open area, away from metal objects, high-
voltage powerlines, radio towers/masts and any portable
or stationary devices sending and receiving radio signals in
order to eliminate magnetic interference.
1. Study [ Fig. 13 ].
2. Switch to the compass calibration procedure. Refer to
learning/calibration' on page 28.
3. Start the procedure.
4. Replace the canopy.
'27.3 Switching between