Status Indication Table - RC Logger 88016RC (RtF) Operating Instructions Manual

28. Status indication table

Type Status
Flight Mode Basic (ACC assisted)
Expert
GPS (position hold)
Flight agility
(Bank selection switch)
R.T.H. Return-to-Home
Lost locator
Flight Error Low battery level 1
Low battery level 2
Fail safe (PPM failed)
Flight Check Error GPS / compass failed
Pressure sensor failed
Gyro failed
Power system failed
(ESC/motor)
Permanent system check
Calibration Tx
Gyro
Compass
Pairing BLE Pairing
Factory state Gyro or compass calibration procedure
36 | Status Indication Table
Trigger
Channel 5 : (+100)
Channel 5 : (0)
GPS fixed - No signal (without Homelock)
GPS fixed - Poor signal (with Homelock)
Channel 5 : (-100), strong GPS signal (with Homelock)
Channel 6
Channel 5 triggered via switch or Transmitter (Tx) off
SWA (Channel 7) or Hard impact (crash or hard landing)
Battery <11.4 V
Battery <10.5 V (pilot must land !)
Loss of RF signal
Start up main board self test
System error (pilot must land!)
Calibration button
Calibration button
Calibration button
Pairing button
Invalid gyro or compass calibration
Rear LED
Magenta
Orange
Refer to chapter "GPS"
Refer to chapter "GPS"
Refer to chapter "GPS"
No indication
White – Blinks continuously (0.5 Hz)
According to flight mode
White – Blinks continuously (1 Hz)
White – Blinks continuously (5 Hz)
White – Blinks continuously (0.5 Hz)
Red – Blinks continuously (1 Hz)
Red – Blinks (fast)
Red
Green
Magenta
According to flight mode
Cyan – Blinks 1Hz (alternating to rear)