88014Rc & 89102Rc Auxiliary Switch Assignment; Assigning A Switch To R.t.h - RC Logger NovaX 350 Operating Instructions Manual

27.5.2 88014RC & 89102RC Auxiliary switch assignment
89102RC / Transmitter
Retractable legs (Ch 7)
(1: Down, 2: Up)
or Gimbal control (Ch 8)
(x and y-axis)
Flight mode (Ch 5)
(1: GPS, 2: Altitude, 3: Basic)
VRA
Fig. 9

27.5.3 Assigning a switch to R.T.H.

> 88014RC RtF: There is no need to perform this step.
> You must assign a 2-way-toggle switch to R.T.H. Do not assign other functions to this
switch.
27.5.3.1 How it works
Channel 5 (Ch 5) is assigned to the flight modes, and each flight mode is triggered by
a specific channel offset value: GPS (-100 %), Altitude (0), and Basic (+100 %). R.T.H.
overwrites the flight modes (see '27.5.3.2 Programming R.T.H.' on page 31) by applying
a (+/-) 30 % channel offset to channel 5, thus triggering R.T.H.
[ Fig. 10 ] illustrates the given explanation, where A shows channel 5 settings in normal
flight (GPS mode is activated) and B the channel settings when R.T.H. is triggered.
R.T.H. (Ch 5)
(1: Off, 2: On)
Bank selection (Ch 6)
(1: AP mode,
2: Sport mode,
3: Custom mode)
VRB
27.5.3.2 Programming R.T.H.
Regardless of the transmitter model you use, the principle behind R.T.H. is the same.
Programm R.T.H. as follows.
1. Assign an aux. 2-position-toggle switch to channel 5.
2. Set an offset large enough so that the channel offset will be (+/-) 30 % after R.T.H. is
triggered. For overwriting GPS and Altitude modes, set a positive offset, and a negative
offset for overwriting the Basic flight mode.
3. Now test your settings. Move the 2-position-toggle switch (R.T.H. switch) to its default
position (position 0 or 1 respectively). Switch the channel 5 switch (flight modes)
through all positions and check for required offsets: GPS (-100 %), Altitude (0), and
Basic (+100 %).
4. Switch the R.T.H. switch to position 1 or 2, respectively. Check for required channel
offset: (+/-) 30 % for channel 5 and R.T.H.
A - Normalflug
Ch 5
-100%
GPS (-100)
-50%
0 Altitude (0)
+50%
Basic (+100)
+100%
Fig. 10
B - R.T.H.
Ch 5 Ch 5
R.T.H
Eingeschaltet Ausgeschaltet
Calibration | 31