Front Led Colours When Calibrating; Binding Transmitter And Receiver; Preparing The Transmitter (Tx); Binding - RC Logger NovaX 350 Operating Instructions Manual

1x
Channel learning
Calibrate
Fig. 8

27.3.2 Front LED colours when calibrating

Channel learning

27.4 Binding transmitter and receiver

88014RC RtF: Receiver and transmitter were bound during
production. Proceed with channel learning.
If re-binding should become necessary at some point,
follow the given steps.
88014RC RtF: Refer to the operating instructions of the
transmitter and receiver (89102RC) for more information
on the binding and learning procedure.
Gyro Compass
Calibrate Calibrate
Gyro Compass
> Use your own 2.4 GHz transmitter to control the »NovaX 350; operate it via PPM.
> Please carry out the configuration of the »NovaX 350 as described in this chapter.
Channel learning is essential as otherwise the »NovaX 350 will not recognize your
transmitting equipment.
> If you use your computer remote control, program it without a mixer in the standard
program.
> Basically, you can configure the controls to your liking. However, it is recommended
that beginners follow the given examples.
> By default, the »NovaX 350 is configured to MODE 2.
> If your transmitter does not provide two 3-way-toggle-switches please refer to the
workaround explained in '27.5.4 Futaba
page 32.
The following sections will guide you through the installation process and set-up. Do not
skip any sections as they are interdependent.

27.4.1 Preparing the transmitter (Tx)

1. Ensure that all mixing is deactivated, throttle curves are linear, trims are centered and
all travel is set to maximum range.
2. Move the throttle stick to its zero position (88014RC RtF: Make sure that the throttle
stick is in its mid-position; the sticks are spring loaded and are centered by default).
3. Set all switches to their default positions (0 or 1 respecively).
4. Connect the supplied PPM receiver to the PPM_IN (PCB-5) and TELEMETRY
(PCB-4) port at the front of the power board.

27.4.2 Binding

> Bind the PPM receiver with your transmitter. Refer to the operating instructions of your
transmitter and PPM receiver.
> Futaba FASST systems: use the 7 channel mode.
®
> In the event that no PPM receiver is detected, the learning mode is not going to be activated.
transmitters without 3-way-toggle-switch' on
®
Calibration | 29