Binding Function; Switch Transmitter Channel - RC Logger RC EYE One Operating Instructions Manual

11. To land the "RC EYE One" again, decrease the throttle slightly until the "RC EYE One" gravitates to the
ground. A somewhat solid touchdown on the ground is no problem and should not be corrected with
jerky throttle movements. Try to touch down where possible in vertical position ("helicopter landing").
Avoid landing with high horizontal speeds ("airplane landing").
12. After landing, turn off the motors (pull back the throttle lever).
13. Practice this starting procedure a few times to get a feel for the "RC EYE One". Once you are reasonably
sure,. you. can. begin. to. steer. the. flight. direction. with. rudder,. nick. and. roll..Always. steer. slowly. and.
carefully.and.practice.the.processes.a.little.before.trying.a.new.flight.manoeuvre..The.first.flights.should.
not last longer than 30 to 60 seconds each.
14. When.you.have.familiarised.yourself.a.little.with.the.model's.flight.properties,.you.may.perform.additional.
exercises..Start.with.simple.flight.manoeuvres.like.a.flying.a.meter.forwards/back.(nod.function)..Then.
practice.hovering.to.the.left/right.(roll.function)..When.you.have.the.practice.you.need,.start.flying.circles.
and.figure.eights.
15. If.you.want.to.terminate.flying,.the.engine.must.be.switched.off.after.landing..Then.disconnect.the.battery.
from the model. Only then must the transmitter be turned off. With the transmitter on, a single signal
sound will be emitted.

12. BINDING FUNCTION

The remote control transmitter and the model are coupled with a special encrypted transmitter signal. This is
referred to as "binding" of the two components that warranty widely interference-free operation. Transmitter
and.model.are.bound.ex.works.already..Outer.influences.(e.g..strong.interference.emission).may.cause.
loss of binding. In this case the "RC EYE One" would no longer react to the transmitter signal (LED in the
model is permanently lit).
To bind your transmitter to your model again, proceed as follows:
1. Connect the battery to the "RC EYE One".
2. Push.the.button.for.flight.mode.selection.for.more.than.three.seconds..The.LED.in.the.model.now.flashes.
red/green alternately.
3. Push the on/off button for more than three seconds with the transmitter switched off. The transmitter
tarts beeping rhythmically.
4. The transmitter and model scan for each other and reconcile their data. After successful binding, the
LED.in.the.model.flashes.in.the.last.flight.mode.selected..The."RC.EYE.One".is.ready.to.start.again.

13. SWITCH TRANSMITTER CHANNEL

The. transmitter. of. the. "RC. EYE. One". may. be. programmed. to. five. different. transmitter. channels.. This.
permits.concurrent.operation.of.up.to.five.transmitters.and."RC.EYE.One".
You may also need to select another transmitter channel if you experience inference from other devices with
915 MHz-technology on the channel that is set (e.g. weather stations, radio headphones, etc.). Proceed as
follows for programming another transmitter channel:
30