AT&T TL92220 Quick Start Manual page 13

Bluetooth
Bluetooth setup
Active devices
Only devices on the active devices list can establish a Bluetooth connection
with the telephone base. Although two paired devices can be connected to
the telephone base, only one Bluetooth cell phone or a headset can be on a
call at a time.
NOTE: When adding, removing, or replacing a Bluetooth device on the active devices list, all
connected devices are temporarily disconnected until the procedure is complete. It may take
up to two minutes to reconnect.
Review the active devices list
. Press MENU/
CID
2. Press or
. Press CID or
/SELECT.
MENU
Connect/disconnect an active device
While in the active devices menu, you may connect or disconnect your
active device.
Press MENU/
.
2. Press CID or
/SELECT.
MENU
. Press CID or
press /SELECT.
MENU
CID
4. Press or
necessary, then press
CID
5. Press or
(whichever is applicable), then press
confirm. The handset displays Device connected/Device
disconnected.
NOTE: When your active device is connected, you are prompted to
select Disconnect. When your active device is disconnected, you are
prompted to select Connect.
on the handset when it is not in use.
SELECT
DIR to highlight Bluetooth, then press
DIR to highlight Active devices, then press
on the handset when it is not in use.
SELECT
DIR to highlight Bluetooth, then press
DIR to highlight Active devices, then
DIR to highlight a device when
/SELECT.
MENU
DIR to highlight Connect/Disconnect
/SELECT to
MENU
2
/SELECT.
MENU
Answering sys
Directory
Cal l log
Intercom
Bluetooth
BLUETOOTH
Download dir
Add cel lular
Add headset
Active devices
SELECT DEVICE
1 Headset A
2 Cel l Phone
Disconnect
Remove active
AC