AT&T TL92220 Quick Start Manual page 10

Bluetooth
Bluetooth setup
When the handset displays Headset A paired to base.
.
Connect now? Press SELECT, then press
on the handset.
• When you already have two devices on the active
devices list, the handset shows Maximum of 2
devices can be connected. You are prompted to
replace an existing headset on the active devices list
(page ).
• When you already have one headset on the active
devices list, the handset shows Only 1 headset can
be connected. You are prompted to replace the
headset on the active devices list (page ).
Headset setup completed Device connected and the corresponding
0.
status icon (
The corresponding light on the telephone base (DEVICE1 or DEVICE2)
turns on.
NOTES:
. The pairing process may take up to one minute. If the pairing process fails, try again.
2. If you put the handset back in the telephone base or charger while pairing, the process
discontinues and the handset returns to idle mode.
Auto connection
When a device is successfully paired with the telephone
base but not connected, the handset displays Headset
setup completed Device not connected and then
Auto-connect function enabled Press SELECT. You can
press /SELECT to exit. You can also connect a device
MENU
manually (page 2).
1 or 2) display when a device is successfully connected.
/SELECT
MENU

Headset A
paired to base.
Connect now?
Press SELECT
Headset setup
completed
Device
connected
Headset setup
completed
Device not
connected
Auto-connect
function
enabled
Press SELECT