Water Valve; Cabinet Removal - Electrolux 5000 Series Service Manual

SERVICE & DISASSEMBLY

WATER VALVE

1. Disconnect dishwasher from power supply.
2. Turn off water supply to dishwasher.
3. Remove kick plate and lower access panel. Removal outer door panel may
be needed to gain access to necessary parts.
4. Remove wire connect and water supply line.
5. Remove two mounting screws holding water valve to front frame.
6. To remove fill hose from valve, rotate water valve. Then remove valve.
7. Reverse procedure to reinstall.

CABINET REMOVAL

1. Disconnect power supply and water supply.
2. Remove drain hose from drain line.
3. Slide dishwasher from under countertop to gain access to cabinet.
4. Remove four screws mounting top trim to tub. Also remove screws on each
side that secure lower trims to cabinet.
5. Remove screws from front flange of cabinet that attach it to tub. (See Figure
34)
6. From rear of cabinet, remove screws that attach it to rear frame. (See Figure
36)
7. Lay dishwasher on its back on a protective pad. Remove screws that attach
the cabinet to bottom of frame. (See Figure 35)
8. Open sides of cabinet and slide cabinet away from tub.
CAUTION
!
Edges are sharp. Protect yourself and be careful not to damage
the insulation blanket around the tub.
27