Inline Heater; Drain Pump - Electrolux 5000 Series Service Manual

SERVICE & DISASSEMBLY

INLINE HEATER

1. Disconnect dishwasher from power and
water supplies. Remove drain line.
2. Remove dishwasher from counter top.
3. Lay dishwasher on its back on a protective
pad.
4. Disconnect wires from heater.
5. Slide clamps from heater and remove
hoses.
6. Reinstall by reversing the procedure. Apply
lubricant to the hose for easier
reinstallation of the hose clamps.

DRAIN PUMP

1. Disconnect dishwasher from power and water supplies. Remove drain line.
2. Remove dishwasher from countertop.
3. Lay dishwasher on its back on a protective pad.
4. Remove wires from drain pump.
5. Removing coupling hose with drain pump aids in pump removal from sump.
6. The locks holding the pump to the sump are located on both ends of the
sump mount. Using a small blade screwdriver,
push up on the locks, will release the pump. (See Figure 46)
7. Remove coupling hose from drain pump.
8. Reinstall in reverse order. Apply lubricant to the hose clamps for easier
installation.
Drain pump
Figure 45
Motor
Water system with tub removed
31
Right
Front
Rear
Left
Heater