Safety Devices; Safety Instructions - Elan HC-600 ODG V1 User Manual

7) SAFETY DEVICES

A) Thermal overload protection
In order to eliminate the risk of fire the motor is equipped with an overheat protection device which will cutoff the
motor's power supply should it reach a high temperature.
In the event that the thermal protection is tripped as a result of malfunction (e.g.: jammed blades, worn out
•
bearings, foreign object in grinding chamber, etc.) the appliance main switch should be turned off immediately
and the main power plug must be disconnected. For further handling of the device contact your local service
provider, and allow the appliance to cool down before any further maintenance.
In the event that the thermal protection is tripped as a result of a long continuous operation (read section 5,
•
for operating intervals) allow the appliance to cool down and reset the thermal cutoff protection by
unplugging the main cable from the socket. On the first operation after resetting a tripped overheat
protection device observe the grinding quality and noise level, and if there are any irregularities shut down the
appliance and call a certified technician for a complete analysis of the appliance.
B) Grinding chamber safety screws
The grinding chamber can be a hazardous area if the proper precautions aren't observed. The hopper safety screw
(fig4.1) and the grinding dial safety screw (fig6.1) should never be removed during normal operation of the
appliance unless the appliance is disconnected from the power source.
8 8 8 8 ) ) ) ) SAFETY

SAFETY INSTRUCTIONS

SAFETY SAFETY INSTRUCTIONS INSTRUCTIONS INSTRUCTIONS
NEVER OPERATE THE GRINDER IF THE BEAN HOPPER IS NOT FULLY SECURED TO THE TOP BLADE HOLDER.
•
BEFORE REMOVING THE HOPPER FOR ANY REASON MAKE SURE TO DISCONNECT THE POWER SUPPLY.
AVOID CLEARING FOREIGN OBJECTS FROM THEGRINDING CHAMBER OR HOPPER WHEN THE APPLIANCE IS
•
PLUGGED INTO A POWER SOCKET.
Never attempt to insert your fingers or any foreign objects into the grinding chamber or blades.
•
Be aware that grinding blades continue rotating for a short while after the grinding operation has ended.
•
BEFORE ANY MAINTENANCE, EVEN FOR CLEANING, ALWAYS DISCONNECT THE POWER SUPPLY.
•
In the event that the appliance has a malfunction or the blades need to be replaced, do not attempt to
•
service the appliance, unless you got the specific training by a certified trainer to do so.
Do not change or tamper with the appliance.
•
Do not use the appliance barefoot or if your hands or feet are damp.
•
Do not use the cable wire to pull and disconnect the power plug.
•
Always keep the appliance dry (internally and externally).
•
Never re grinds grinded coffee.
•
Never attempt grinding anything else other than coffee beans.
•
©ELAN (Changzhou) Hardware Co. Ltd.
Version 2.1, September 2012
11