Safety Devices; Safety Instructions - Elan HC-880 Operating & Service Manual

HC‐880 – Manual book
6) SAFETY DEVICES
1. Thermal overload protection:
In order to eliminate the risk of fire, the motor is equipped with an over‐heat protection
device which will cut‐off the motor's power supply should it reach a high temperature.
In the event that the thermal protection is tripped as a result of malfunction (e.g.: jammed
blades, worn out bearings, foreign object in grinding chamber, etc.) the appliance main
switch should be turned off immediately and the main power plug must be disconnected.
For further handling of the device contact your local service provider, and allow the
appliance to cool down before any further maintenance.
In the event that the thermal protection is tripped as a result of a long continuous operation
allow the appliance to cool down. Reset the thermal cut off protection by unplugging the
main cable from the socket. On the first operation after resetting a tripped over‐heat
protection device observe the grinding quality and noise level, and if there are any
irregularities shut down the appliance and call a certified technician for a complete analysis
of the appliance.
2. Beans conveyor and grinding chamber safety cover:
The grinding chamber can be a hazardous area if the proper precautions aren't observed.
The beans hopper is equipped with hands and fingers safety protector. Never remove the
safety protector while the HC880 grinder is plugged in.
3. Bag presence switch:
A bag presence switch was installed In order to avoid foreign bodies plunged into the
grinding house from powder's outlet direction and in order to avoid accidental grind of
beans without collecting bag for the powder.
Never operate the HC880 grinder when the bag presence switch is disassembled or
bypassed
7) SAFETY INSTRUCTIONS
1. NEVER OPERATE THE GRINDER IF THE BEAN HOPPER IS NOT FULLY SECURED TO THE
GRINDER'S BODY. BEFORE REMOVING THE HOPPER FOR ANY REASON MAKE SURE TO
DISCONNECT THE POWER SUPPLY.
2. NEVER CLEAR FOREIGN OBJECTS FROM THE BEANS CONVEYOR OR BEANS HOPPER WHEN
THE APPLIANCE IS PLUGGED INTO A POWER SOCKET.
3. BEFORE ANY MAINTENANCE, EVEN FOR CLEANING, ALWAYS DISCONNECT THE POWER
SUPPLY.
4. Never attempt to insert your fingers or any foreign objects into the grinding chamber or
blades.
5. Be aware that grinding blades continue rotating for a short while after switching OFF the
appliance and the grinding operation has ended.
6. In the event that the appliance has a malfunction or the blades need to be replaced, do
not attempt to service the appliance by yourself.
7. Do not change or tamper with the appliance.
8. Do not use the appliance barefoot or if your hands or feet are damp.
9. Do not use the cable wire to pull and disconnect the power plug.
10. Always keep the appliance dry (internally and externally).
11. Never put grinded coffee into the hopper.
12. Never attempt grinding anything else other than coffee beans.
ELAN (Shanghai) Industry and Trading CO.,LTD. Page 8 of 12
2011.05 Ver.1.2