Unpacking And Installation - Elan HC-600 ODG V1 User Manual

4) UNPACKING AND INSTALLATION:

Warning: All appliances' technical handling operations such as installation, maintenance, or service
should be performed by certified personnel or by your local dealer.
After opening the box, make sure that the appliance is intact and that there is no visible damage. If there is
•
any doubt, DONOT use the appliance and call your local dealer for further assistance.
Unpack the carton box carefully. For your convenience we suggest storing all packaging materials where they
•
can be used in the future, whenever the appliance's transportation is necessary.
Place the grinder on a stable flat counter in a dry area away from water or water splashes.
•
Position the coffee residue tray underneath the body in front of the appliance.
•
Install the beans hopper firmly on top of the body inside the top blade holder.
•
Fasten the hopper to the appliance body by means of the supplied screw. (fig.4.1) Make sure that the screw is
•
inserted completely through both holes in the hopper and in the top blade holder.
NEVER OPERATE THE GRINDER IF THE BEAN HOPPER IS NOT FULLY SECURED IN ITS POSITION.
•
Before plugging in the electrical cord, make sure:
•
The appliance voltage and frequency rating (according to the bottom cover label) is the same as the
o
supply mains.
The wall socket is fitted with an efficient ground contact. DONOT plug the appliance into the supply
o
mains if the ground system was not positively checked to be in compliance with current safety rules.
IT IS COMPULSORY TO GROUND THE APPLIANCE. The manufacturer can not be held responsible in
the event that this regulation is not complied with.
The power consumption of the appliance (according to the backside label) is consistent with the
o
relevant wall socket capacity.
The wall socket is protected against short outs and power surges.
o
Do not use extension cables, plug adapters for multiple sockets, or make shift connections.
o
Plug in the appliance.
•
Upon first time operation, and before placing beans into the hopper, VISUALLY check that the blade rotation
•
direction is clockwise by switching the appliance ON for a short while.
Should the rotation direction be wrong, do not use the appliance and contact your local dealer for further
•
instructions.
©ELAN (Changzhou) Hardware Co. Ltd.
Version 2.1, September 2012
Fig4.1
5