Yamaha RAPTOR YFM125RA Service Manual page 127

2. Install:
• Copper washers
• Brake hose
• Union bolt
Brake hose union bolt
27 Nm (2.7 m·kgf, 20 ft·lbf)
EWA13530
WARNING
Proper brake hose routing is essential to
insure safe vehicle operation. Refer to
"CABLE ROUTING" on page 2-27.
TIP
• While holding the brake hose, tighten the
union bolt as shown.
• Turn the handlebar to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables,
leads). Correct if necessary.
New
3. Fill:
• Brake master cylinder
(with the specified amount of the recom-
mended brake fluid)
Recommended fluid
DOT 4
EWA13540
WARNING
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing brake
fluids may result in a harmful chemical
reaction, leading to poor brake perfor-
mance.
• When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the
boiling point of the brake fluid and could
cause vapor lock.
ECA13540
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
4. Bleed:
• Brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-11.
5. Check:
• Brake fluid level
Below the minimum level mark "a" → Add
the recommended brake fluid to the
proper level.
Refer to "CHECKING THE BRAKE
FLUID LEVEL" on page 3-12.
4-28
FRONT BRAKE