Dimms - HP ProLiant DL120 Gen9 Maintenance And Service Manual

WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause ESD.
To remove the component:
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
Remove the air baffle (on page 31).
5.
Disconnect the fan cable from the system board and remove the fan.
6.
To replace the component, reverse the removal procedure.

DIMMs

To identify the DIMMs installed in the server, see "DIMM slot locations (on page 91)."
To remove the component:
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
("Access panel" on page 36).
Removal and replacement procedures 46