HP LE2201w User Manual page 28

To set the timer:
1. Press the
2. Scroll down and highlight Management.
3. Press the
4. Scroll down and highlight and select Sleep Timer > Set Current Time.
NOTE:
Time. Note that the time is displayed in a 24–hour clock format. For example, 1:15 p.m. is displayed
as 13 hours 15 minutes.
A power failure or loss of power to the monitor will cause the timer to reset to 00:00. If this occurs,
you will need to reset the sleep timer mode.
5. Press the
6. Press the
7. Press the
8. Press the
9. Press the
10. After setting the current time, the highlight automatically skips to Set Sleep Time hours. Repeat
steps 6 through 9 to set Sleep Time.
11. If you do not want to set Sleep Time, press the
Return to exit the menu.
12. After setting Sleep Time, the highlight automatically skips to Set On Time hours. Repeat steps 6
through 9 to set On Time.
13. Set the Timer mode to On to activate the Sleep Timer settings.
14. When you are finished, select Save and Return to exit the menu.
The fifth selection, Sleep Now, turns the monitor backlights off immediately and stays in sleep mode
until the next On Time activates or a monitor button is pressed.
22 Chapter 4 Operating the Monitor
Downloaded from ManualMonitor.com Manuals
Menu button on the monitor front panel to display the OSD Menu.
Menu button to select Management.
You must set the current local time before you reset the time for Sleep Time or On
Menu button once to enter the adjustment mode for hours.
- (Minus) or + (Plus) button to adjust the hour.
Menu button again to enter the time for minutes.
- (Minus) or + (Plus) button to adjust the minutes.
Menu button to lock in the time chosen.
Menu button twice, then select Save and
ENWW