Table 4-2
Icon
ENWW
Downloaded from ManualMonitor.com Manuals
OSD Menu (continued)
Main Menu
Video Input
Control (select
models)
Information
Factory Reset
Exit
Submenu
Description
Selects the video input signal. DVI is the factory
default.
Switch Video Input
Selects the other (VGA or DVI) video input signal.
Default is DVI.
Auto-Switch Input
Turns the system's automatic video signal input to on
or off. The factory default is On.
Default Video Input
Selects the default or primary video input signal when
the monitor is connected to two active and valid video
sources. The monitor will automatically determine the
video format. The default input selection is DVI.
Analog — VGA — Selects VGA input.
Digital — DVI — Selects DVI input.
Selects and displays important information about the
monitor.
Current Settings
Provides the current input video mode.
Recommended
Provides the recommended resolution mode and
Settings
refresh rate for the monitor.
Serial Number
Reports the serial number of the monitor. The serial
number is needed if contacting HP technical support.
Version
Reports the firmware version of the monitor.
Backlight Hours
Reports the total hours of backlight operation.
Service Support: http://
www.hp.com/support
Returns all OSD menu settings and DDC/CI controls
to the factory default settings, except the Language.
Exits the OSD menu screen.
Adjusting the Monitor Settings
19
Need help?
Do you have a question about the LE2201w and is the answer not in the manual?