Table of Contents
Advertisement
11 Camera Arm Installation
The back box is provided with arm hangers on both sides to hold the camera/
arm module on the back box to facilitate installation. (Figure 8)
NOTE: The arm hangers function perfectly at any orientation of the junction box and will firmly hold
the camera and junction box cover in any of the wall, ceiling, or parapet mount configurations.
1. Insert the two (2) pins into the channel and slide the camera / arm module
down until it locks in place on the arm hanger.
WARNING: Serious injury and / or damage to the unit can occur if the camera / arm module is not fully
locked in place.
2. Connect Ethernet and terminal block cables from the camera to the left side
(camera side) of the junction box.
3. If I/O connections are being used, attach them to the appropriate I/O
terminals on the center terminal block of the back box (Figure 9).
4. After all connections are made in the back box, remove the camera / arm
hanger and secure to the back box by tightening the four (4) screws with the
supplied Allen wrench (Figure 10).
Figure 9
Figure 10
8
Figure 8
Advertisement
Table of Contents
