Table of Contents
Advertisement
11. Factory Reset
1. Press and hold the "Reset" button for
10 seconds as illustrated in Figure 11.1.
12. Complete the Dome Camera
Installation
1. Attach the tether from the dome trim ring to the
tether mounting point in the enclosure as shown in
Figure 12.1.
2. Rotate the black shroud inside the dome trim ring
cover so it aligns with the camera position.
3. Place the supplied desiccant pack inside the dome as
shown in Figure 12.2 to prevent fogging due to
moisture that is present when installing the camera.
Use the supplied cable tie to keep the desiccant from
falling down into the dome bubble.
4. Attach the dome trim ring cover with shroud to the
enclosure by tightening the three tamper-proof screws
with the supplied Torx T-20 security wrench.
13. PC Configuration of Alliance-mx
NOTE: The default user name for all IQeye devices is "root" and the default
password is "system".
IQeye cameras are configured for DHCP and will have an IP address assigned if
a DHCP server is on the network. If a DHCP server is not available, the camera IP
address will need to be configured using either IQfinder or IQmanager depending on
the number of cameras being installed.
Figure 11.1
9
Figure 12.1
Figure 12.1
Hide quick links:
Advertisement
Table of Contents
