Camera/Arm Installation - Iqinvision IQeye Sentinel Series Installation And Operating Instructions Manual

10. Camera/Arm Installation

The back box is provided with arm hangers on both sides to hold the
camera/arm module on the back box to facilitate installation.
NOTE: The arm hangers function perfectly at any orientation of the junc-
tion box and will firmly hold the camera and junction box cover in any
of the Wall, Ceiling or Parapet mount configurations.
1. Insert the two (2) pins into the
channel and slide the camera/arm
module down until it locks in
place on the arm hanger.
WARNING: Serious injury and/or
damage to the unit can occur
if the camera/arm module are
not fully locked in place.
2. Connect Ethernet and terminal block
cables from the camera to the left-side
(camera-side) of the junction box.
3. If I/O connections are being used, attach
them to the appropriate I/O terminals on
the center terminal block of the back box as shown in Figure 9.
4. After all connections are made in
the back box, remove the camera/
arm from the hanger and secure to
the back box by tightening the four
(4) screws with the supplied Allen
wrench.
9
Figure 8
Figure 9
Figure 10