Removal Of Dome Cover And Camera Assembly; Install Mounting Plate - Iqinvision IQA32NI-B5 Installation And Operating Instructions Manual

7. Removal of Dome Cover and Camera
Assembly
1. Using the supplied Torx T-20 security tool,
loosen the four screws holding the dome cover
to the rest of the Alliance camera assembly.
Note that these screws are captively held to the
dome cover and should not be removed from
the dome cover trim ring.
2. Once loosened, lift the dome cover and trim
ring away from the camera assembly.
3. Locate the removal tabs where the camera
assembly connects to the mounting plate as
shown in Figure
4. Press any two of the three removal tabs and pivot the camera assembly up and
away from the mounting plate. Carefully thread the connection cables out
through the mounting plate hole.

8. Install Mounting Plate

1. Position the supplied mounting template on the surface in the location where the
camera will be installed. Trace and drill the mounting holes and the cable pass
through hole as indicated.
2. Using the supplied hardware, or equivalent hardware, install the mounting plate
to the intended surface.
3. Pull cabling through the pass-through hole.
NOTE: If you are installing your Alliance into a ceiling tile, please be sure to
use hardware designed to secure the camera assembly to such a surface, and
that the ceiling tile material being mounted is secure.
7.1.
6
Removal Tabs
Figure 7.1