Pace Sky Using Manual page 49

2 Turn your TV on and press tv on your Sky remote control.
3 Hold down select and the red key together for about two seconds, until the
red light on your Sky remote control blinks twice.
4 Press tv on your Sky remote control again.
5 Key in the four-digit code for your brand of TV. The light on your Sky remote
control blinks twice.
If the light blinks once only, check the code for your brand of TV and start
again at Step 1.
6 Press the standby key
If your TV switches off, press select.
The light on your Sky remote control blinks twice.
If your TV does not switch off, press tv, then press the standby key.
7 Repeat this action (press tv, then press the standby key) until your TV turns
off, then press select.
If the light on your Sky remote control blinks three times, it has checked all
the possible settings for the code you used. Check that you have the correct
four-digit code and start again at Step 1.
8 Turn your TV back on again and then press tv guide.
If you see the TV Guide screen, the Sky remote control setup process is
complete.
If you do not see the TV Guide screen, you must now complete the following
steps:
1 Press tv on your Sky remote control.
2 Hold down select and the green key at the same time for about two seconds,
until the red light on your Sky remote control blinks twice.
3 Key in the number of the channel on your TV that you use for watching
satellite TV.
4 Press select on your Sky remote control.
The red light blinks and the Sky remote control setup process is now complete.
If you still have problems, call Sky Customer Service. To find the Sky
Customer Service number, select the Telephone Numbers option from the
Services screen and look under Sky.
Using your Sky box
on your Sky remote control.
45