Changing The Digital-Audio Output Settings; Resetting Your Set-Top Box - Pace DS810 Manual

usInG tHe setuP menu
CHanGInG.THE.DIGITaL-aUDIO.
OUTPUT.SETTInGS
This screen allows you to set your set-top box
to automatically send Dolby Digital audio (if it
is available for the current programme) to any
equipment you have connected to the oPtICAL
AuDIo out connector .
From the Setup menu (see page 24), highlight
'Digital Audio Output' then press oK . The Digital
Audio screen appears (see right) .
Use the table below to help you choose the setting
you want . Then use the L R buttons to select the
setting . The factory setting (when your set-top box
is new or if you reset your set-top box as described
below), is shown with a star * against it .
Saving.your.changes
When you have made the changes you wish to
make, press oK .
If you do not want to save your changes, press the
exIt button .
Item settings
Auto-handling *Off
On
RESETTInG.YOUR.SET-TOP.bOx
You can reset your set-top box if necessary .
It will return to the state it was in when you plugged
it in for the first time .
ImPoRtAnt: All the settings you have changed
and any Favourite channels you have created
will be lost when you carry out a full reset.
If you wish to carry out a full reset, press menu to
display the Main menu .
Highlight 'Setup menu' then press oK to display the
Setup menu .
28
Comments
You should set this to 'On' only if you have connected suitable audio
equipment to the oPtICAL AuDIo out connector .
The setting 'On' means that, if Dolby Digital audio is being transmitted, this
will automatically be sent to the oPtICAL AuDIo out connector .
The setting 'Off' means that your set-top box will automatically select the
first-available audio stream for the programme .
Highlight 'Factory reset' then press oK to display the
Factory reset screen .
To confirm the full reset, use the L R buttons to
highlight Yes then press oK .
Or, to cancel the reset, highlight no then press oK .
After the set-top box has reset itself, you will have to
choose the Language and Resolution settings again .
Then, your set-top box will carry out its Network
scan, using the satellite dish configuration you have
selected (see pages 10 - 13) .