Pace DS810 Manual page 37

Problem
You cannot see the Zapping
Window .
You see the on-screen
message: 'Unknown TV
channel' .
The picture appears to be
either:
(i) 'squashed' (from side to
side or from top to bottom);
or
(ii) cut off at the top and
bottom of the screen .
You cannot hear Dolby
Digital audio from
equipment attached to
the optical digital-audio
connector .
Possible cause
The Display time setting has
been set to
'0 seconds / Off' .
You have selected a channel
number that currently has
no channel associated
with it .
The TV screen format setting
on the SD settings screen
has not been set to match
your TV .
(i) The programme is
not transmitted with the
required Dolby Digital audio
stream .
(ii) The Dolby Digital audio
stream is available, but
Auto-handling is set to 'Off'
on the Digital Audio Output
screen (this is the factory
setting) .
tRouBLesHootInG
suggested remedy
Set it to '3' , '5' or '10' seconds (as required)
instead (see page 31) .
In the future, this channel number may be
used for a channel . In the meantime, select a
different channel .
Display the SD settings screen (see page
26) . If you have a widescreen TV, set '16:9' .
Otherwise set '4:3' .
note: If you have a widescreen tV,
its remote control may have a 'zoom'
button which alters the way that the
picture appears on the screen, so you
may also need to use this button.
Check that audio options are available
as follows . While you are watching the
programme, press the oPt button .
If Options are available, the Options Window
appears . Highlight the 'Audio' option, then
use the U D buttons to highlight 'Dolby
Digital' (if present), then press oK .
If, generally, you wish to hear Dolby Digital
audio when it is available, change Auto-
handling to 'On' .
35